Can any remember what the size differences is between a
Aus Spec Rad
Jap Spec Rad
Pic of a japspec here
Can any remember what the size differences is between a
Aus Spec Rad
Jap Spec Rad
Pic of a japspec here
16mm i thought was the thicker one and thinner was 10mm, but 10mm just seems too thin so not sure if my memory is correct there...
You can get factory type (i.e not stupid fully alloy) with a 26mm core if you need. If you are (or can do) an oil cooler it will probably do more good than just whacking a bigger radiator in there.
Yer 10mm is to small i think , im thinking Jap 16mm and Aus 20mm.
Ill do some recon next time im at the wreckers.
I thought it was 10, but I have a 26mm in my challenge car
The rules only detail the stock width & height - no issue with thickness
I'm just running a new heavy duty unit which is 16mm ($85 from eBay- plastic top and bottom)
Out on the track she runs at 85 degree rock solid - even during the 45 minute enduro
I'm planning on putting some mesh over the bumper air intake cos the radiator fins are copping a hiding (stones and rubber)
Sweet ill pull the PWR out of JAPSSS :P
10mm if i recall correct was the jap core thickness.