Search:

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. Replies
    5
    Views
    4,426

    N14 an and NX shafts are the same N15 shafts are...

    N14 an and NX shafts are the same
    N15 shafts are longer than N14 shafts,

    BaronVonKebabalot and I have 100% confirmed this by comparing our shaft width and length side by side (if you know...
  2. Ethanolaholic I believe you now have something...

    Ethanolaholic
    I believe you now have something that belongs here :)
  3. Putting 4 pots on the front and Gti-r brakes on...

    Putting 4 pots on the front and Gti-r brakes on the rear is a bad idea, I speak from experience and I've crunched the numbers through a brake bias calculator and you end up with an inefficient brake...
  4. Replies
    21
    Views
    42,579

    Unpredictable

    Unpredictable
  5. Replies
    21
    Views
    42,579

    In one word, sum up your pulsar

    In one word, No more and no less (especially this)
    Just comment with one word that completely sums up your pulsar
  6. Replies
    8
    Views
    157,380

    Sticky: You're a legend, This is why you get paid the big...

    You're a legend, This is why you get paid the big bucks Paullus
  7. Replies
    13
    Views
    45,801

    The top of my intercooler is bolted to the bottom...

    The top of my intercooler is bolted to the bottom of my reo bar
  8. Replies
    22
    Views
    29,686

    Bengineering Made 99fwkw on a healthy sr20de with...

    Bengineering Made 99fwkw on a healthy sr20de with a 2.5inch exhaust system + Pon cams and NO tune and factory air box,

    With your setup I expect you to pull the same sort of numbers, close to the...
  9. Replies
    5
    Views
    4,885

    Mr Kebabalot, You have a VE+T, which I'm all...

    Mr Kebabalot,

    You have a VE+T, which I'm all for doing, I love the vvl motors,
    The main reasons being that you have piston oil squirters, the VE head can take a lot of revving and abuse because...
  10. Replies
    13
    Views
    45,801

    Sorry I'll fix the post up, I made a mistake,...

    Sorry I'll fix the post up, I made a mistake,
    Should be a very nice fit Ethanolaholic
  11. Replies
    5
    Views
    4,885

    And as for a De holding 10 pounds, if it's a...

    And as for a De holding 10 pounds, if it's a healthy motor it can definitely hold it just fine, that's about what you want to run if you do go down that road but I wouldn't go turning it up much more...
  12. Replies
    5
    Views
    4,885

    Hey OZY-20, I have personally done many engine...

    Hey OZY-20, I have personally done many engine conversions and +T conversions,
    A Gti-r or bluebird conversion is the best way to go about it,
    If you compare the 2 processes, they take the same...
  13. Replies
    13
    Views
    45,801

    I run a 720x200x90mm intercooler, (550mm core)...

    I run a 720x200x90mm intercooler, (550mm core)
    It doesn't require cutting the reo bar, infact it butts up to and is bolted to the bottom of it,
    It doesn't stick out of the bottom of the bar,
    It...
  14. Replies
    6
    Views
    5,849

    In my jappy, I have had all 4 radiators, 10mm,...

    In my jappy, I have had all 4 radiators, 10mm, 16mm, 26mm, 50mm alloy,
    I prefer the 26mm as it allows me to use stock fans, clear everything, and it was half the price of the 50mm ones, and the car...
  15. Replies
    27
    Views
    87,434

    Don't be ridiculous, if you go boosted and reach...

    Don't be ridiculous, if you go boosted and reach over the 300kw mark you'll hardly ever break anything

    1049
    1050
    1051

    You'll never melt Cp pistons, a genuine Greddy turbine wheel, break...
  16. Replies
    17
    Views
    11,578

    All you guys, Check out the 2 articles i have...

    All you guys,
    Check out the 2 articles i have posted in this section,
    Mike Kojima talks about roll centre, roll couple, suspension geometry, bump steer, toe steer, over lowering and much more, ...
  17. Replies
    38
    Views
    46,164

    As you can see, WEIGHT TRANSFER and AVAILABLE...

    As you can see, WEIGHT TRANSFER and AVAILABLE TRACTION are the 2 things that are responsible for all this happening,

    Just so people can understand this completely,
    I want to give another...
  18. Replies
    38
    Views
    46,164

    There's something I want to explain to you all as...

    There's something I want to explain to you all as there seems to be a lot of debate about upgrading rear brakes

    What I want to make very clear to you all is that there's more to braking than just...
  19. Sticky: Why lowering your Pulsar will make it handle worse unless it's done properly

    http://www.motoiq.com/MagazineArticles/ID/2804/The-Ultimate-Guide-to-Suspension-and-Handling-Its-All-in-the-Geometry-Part-One-The-Roll-Center.aspx
  20. Sticky: The ultimate suspension information thread

    The following link is a guide that covers everything you need to know about suspension for our cars,
    It covers N14, N15 and N16 Pulsars,

    Everything from springs to shocks to bushings, bracings...
  21. Replies
    6
    Views
    4,554

    Then based on the Info you have given me I can...

    Then based on the Info you have given me I can only assume that the 2nd plug has oil on it due to the tube seal leaking, and that the 3rd and 4th plug are getting oil on them due to unwanted oil...
  22. Replies
    4
    Views
    4,169

    I had a funny reading gauge and picked up a fuel...

    I had a funny reading gauge and picked up a fuel sender from the wreckers,
    It was out of a aus spec Q and worked perfectly in my Jap spec SSS so I'd say they are compatible between all N14s,

    As...
  23. Replies
    27
    Views
    87,434

    Really? Wow, Vlad sounds like the kind of guy I'd...

    Really? Wow, Vlad sounds like the kind of guy I'd like to be
  24. Replies
    17
    Views
    31,119

    1006 Out of the nissan service manual, Lots...

    1006

    Out of the nissan service manual,
    Lots of people say it doesn't seem right,
    But all I can say is its straight from nissan and they should know best
  25. Replies
    31
    Views
    26,116

    The car is a little lower then I'd like it, I...

    The car is a little lower then I'd like it, I will be raising it soon because I want to get my control arms/ steering rack arms and everything else back closer to how it comes stock,
    Spring rates...
Results 1 to 25 of 27
Page 1 of 2 1 2