• 6 Speed Conversion Part Numbers

    Part numbers of parts you will need**

    25240-8996E - Oil Pressure Switch
    92400-0N600 - Water pipe from head to heater - VE SPECIFIC
    30630-80E0A - P12/GTI-R Slave Cylinder assembly
    39780-55E10 - P12 driveshaft support bracket
    34101-6Z910 - Cable shifter (inside cabin)
    34414-6Z900 - Shift control cables
    34448-8J000 - Shift control cable gearbox bracket
    74965-4Z700 - Transmission hole cover (goes under the new shifter assy)
    32702-????? - Speedo sensor for RS6F51x gearbox. Features N15SSS loom plug.
    11253-AU400 - Gearbox mount (gearbox)
    11220-AU400 - Gearbox mount (chassis)


    See pictures for part numbers of washers, pins and clips required for control cables.


    Fuel Rail barb is available from me $30 ea includes o-ring
    P12 driveshaft support brackets, i still have a couple $140 ea

    Part numbers of parts you will need if you disassemble the gearbox and install an LSD**

    38411-8U000 - Helical LSD assy for RS6F51A gearbox
    38440-8H500 - Diff bearing x1
    31377-8H510 - Self Sealing case bolts x2*
    38342-81X01 - Driveshaft seal - clutch side/driver side
    38342-81X00 - Driveshaft seal - gearsbox side/passenger side
    32113-8H500 - Input shaft seal
    32292-6J000 - Roll Pins x5*
    32812-6J000 - Stopper rings x4*
    32999-8H500 - Shift control assy self sealing bolts x4*
    32182-8H500 - Shift control assy o-ring
    32834-8H52A - Check ball plug x4*
    32181-8H500 - Stopper Bolt*
    32838-8H51A - Pin Shift Check*
    32102-8H500 - Bore Plug gearbox seal


    Part numbers of parts you might need**

    25080-89907 - Dash Temp sensor - N15 S2 SSS
    22630-44B20 - ECU Temp sensor - N15 S2 SSS
    13050-1N500 - Water temp sensor assy gasket
    30678-01J00 - Slave cylinder retaining bolts x2
    21200-0C811 - Thermostat 76.5degC
    13271-65F00 - Rocker cover gasket for 20V spark plug wells
    21010-53J05 - SR20VE P12 water pump
    16119-1N510 - N1 Throttle Body
    22620-31U0A - N1 TPS
    16175-1N500 - N1 TB Gasket


    * - some of the bolts/pins/clips for gearbox disassembly could be reused, but i believe to do a job once and do it right. Those parts listed are recommended for repalcement by the Service Manuals
    ** - i never said they were cheap !