I'm wondering whether someone has experienced the same issue I have and can provide some advice on how to sort it out. I have a series 2 N15 sedan (GA16), and I'm trying to retrieve the fault codes to further diagnose an issue I'm having. As far as I know, I need to bridge the two top right pins on the Consult port and then remove the bridge after a couple of seconds, whilst the key is in in the on position, but not running. I have tried this multiple times with a piece of wire/paperclip etc and no matter what, the check engine light does not flash any codes, not even a code 55. I have also tried a friend's scan tool, which suits multiple cars but does have a Consult adapter, with the key in the on position as well as whilst the car was running, to no avail either. I'm wondering why I'm having this issue? Is there anything else that needs to be done before I can retrieve the fault codes, like put the ECU into diagnostic mode or something like that?
Any help would be greatly appreciated.
Cheers, Jarryd