Hi there, anyone know the part numbers for all the seals/ Bushings for the gearbox? Input shaft seal, axle seals, clutch lever seal and bushing and the case seal or do you use sealant for that? Cheers.
Hi there, anyone know the part numbers for all the seals/ Bushings for the gearbox? Input shaft seal, axle seals, clutch lever seal and bushing and the case seal or do you use sealant for that? Cheers.
Case halves are gasket goo / silicone rtv only. Run a thin bead around the lip on the inner edge of each of the bolt holes to seal it. Don’t use too much and give it 24 hours to cure before you put oil into it.
Anyone know that part numbers for the clutch bushing and seal?
Bump, anyone recommend the OEM KP510-00150 sealant for the gearbox or can anyone recommend a sealant? Will get the OEM sealant if that is best but would prefer aftermarket as the sealant cost $90 for a tube from my local or about $50 off amayama with shipping. Cheers.
These are the seal numbers for the driveshafts:
https://pulsar.org.au/forums/content...-Gearbox-Seals
Genuine
Passenger side 38342-8E002
38342-31x02
38342-31X00AU
(I think the bottom is the current number, others are superseded)Drivers side (non LSD) 38342 8E001
Aftermarket
Passenger side M42-90-9.5-13 Drivers side (non LSD) M33-56-8-13 Input shaft M25-40-7
And here's a few misc numbers from my spreadsheet:
AH1314F Input shaft seal (I think I got this from a bearing shop (i.e not a genuine number from memory)). 7E-BKS28X45X18 Gearbox bearing (NTN) (not sure which one) R06A68VPX1 Gearbox bearing (NTN) (not sure which one)
Paul
11.9@125