Search:

Type: Posts; User: PhilSSStevenson

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Nissan N14 SSS Oz. Spec - MODERN MOTOR REVIEW - 1992

    Hi All,

    I purchased this edition of Motor in 1992. Bought my Red Jett in 1992. Still have both.

    Enjoy the read.

    Cheers.

    16011602160316041605
  2. This is what ya need: ...

    This is what ya need:

    http://www.nissanforums.com/ga16de-1-6l-engine/168184-ga16de-intake-thread.html
  3. Replies
    44
    Views
    2,874

    CozzmO, you are the man! How about a few pics...

    CozzmO, you are the man!

    How about a few pics of the lathe and the master at work.

    Cheers.
  4. The RHS K&N filter is probably not legit, but...

    The RHS K&N filter is probably not legit, but lets ERG gases out a little (vent to air). I clean that filter every 20,000.

    Note I have removed all the ERG stuff on the intake manifold.

    Here...
  5. The little filter is in fact a cheap fuel filter,...

    The little filter is in fact a cheap fuel filter, that is a final clean after going through the oil catch can and back into the intake manifold - not seen in bottom left of pic, located behind the...
  6. Replies
    7
    Views
    890

    OK, job done to perfection. Rear sway bar now...

    OK, job done to perfection.

    Rear sway bar now doing it's job.

    Phew! Vast improvement with turn-in, and the rest.

    I have read that some BMW's sway bar brackets snap off, and these dudes got...
  7. Take a look at two pics of the Red Jett. Cold...

    Take a look at two pics of the Red Jett.

    Cold Air Intake at bottom left (passengers side) of front spoiler. Used end of a funnel to increase opening to 120 mm, for ram effect.

    80 mm flex pipe...
  8. Replies
    7
    Views
    890

    Oh well, over time there is metal fatigue. As you...

    Oh well, over time there is metal fatigue. As you start to improve areas.

    Started to get a clunk/bump/knock from right rear end.

    Had a geezer, and low and behold, the side sway bracket, had...
  9. Replies
    44
    Views
    2,874

    you need four (4) of the buggers. Cheers

    you need four (4) of the buggers.

    Cheers
  10. Replies
    44
    Views
    2,874

    Agreed… Good luck to all those that are...

    Agreed… Good luck to all those that are searching.
  11. Replies
    44
    Views
    2,874

    Found these on eBay. from the USA Might just...

    Found these on eBay. from the USA

    Might just do the trick. They look almost identical. Not cheap! It will cost you circa AU$100 for a set of four including postage.
    ...
  12. Replies
    2
    Views
    152

    It is all in this thread Dude. ...

    It is all in this thread Dude.

    http://pulsar.org.au/forums/showthread.php?697-Shifter-linkage-bushing

    Cheers...
  13. Replies
    4
    Views
    241

    If you buy used injectors, get them...

    If you buy used injectors, get them ultrasonically cleaned before fitment.

    It will be worth it.

    For the Red Jett I got one of those mobile vans to clean them. Saw it happen. Before and after....
  14. Replies
    13
    Views
    669

    OK, verdict is now in. The BlueDevil product has...

    OK, verdict is now in. The BlueDevil product has fixed the tranny leak. No more there.

    This stuff was like water and clear. I can recommend it. Can only be sourced from the US....
  15. Replies
    13
    Views
    669

    It was a weight reduction thing I did. Spoke to...

    It was a weight reduction thing I did. Spoke to Colin Chapman about it...:rolleyes:
  16. Replies
    13
    Views
    669

    Well, tranny oil changed today. As this leak has...

    Well, tranny oil changed today. As this leak has been, I think, causing my linkage to tighten after a hot uphill run.

    However, I got about three litres out and in good colour. Minute filings...
  17. Replies
    13
    Views
    669

    Ah-hem… I was a DIY guy. Now gettin' long in the...

    Ah-hem… I was a DIY guy. Now gettin' long in the tooth and sick of skinned knuckles and bruised arms. I wish I had a hoist. That would be lotto for me.

    No, I'm gently rockin' the Jett towards...
  18. Replies
    13
    Views
    669

    Oh what have you done to me Cozzm0? OK, you...

    Oh what have you done to me Cozzm0?

    OK, you put me to shame. The leak has got worse over the last four years. Huh, I already knew about it.

    OK, who ever get's the Red Jett in five years...
  19. Replies
    13
    Views
    669

    It is the join. Confirmed. As I do only 2,000...

    It is the join. Confirmed.

    As I do only 2,000 klicks a year now, (with 135,000 on the odo after 25 years) not sure if I wanna spend to professionally fix it at this time, even though I like it...
  20. Replies
    13
    Views
    669

    Transmission gearbox leaking...

    Finally found the culprit that causes a stiff gear linkage after a hot run.

    The forkin’ transmission is leaking. Changed the tranny oil two years ago and I think there ain’t much left. Nice old...
  21. Replies
    21
    Views
    1,249

    How could you suggest that for a beautiful SR20? ...

    How could you suggest that for a beautiful SR20? ;)
  22. Replies
    10
    Views
    740

    Also, check this thread out: ...

    Also, check this thread out:

    http://pulsar.org.au/forums/showthread.php?697-Shifter-linkage-bushing
  23. Replies
    21
    Views
    1,249

    Five minutes… Don't go over 3500 rpm...

    Five minutes…

    Don't go over 3500 rpm...
  24. For Sale FAST FOURS and HOT 4s magazines - Gold Coast, QLD 4211

    For Sale/Wanted/Wrecking for_sale_parts
    Brief Description FAST FOURS and HOT 4s magazines
    Condition Very good condition
    City/Town Gold Coast
    State QLD
    Postcode 4211
    Contact...
  25. Replies
    21
    Views
    1,249

    I remember now… As I only do very short runs,...

    I remember now…

    As I only do very short runs, max 30 mins, once a week, the '5' is why…
Results 1 to 25 of 132
Page 1 of 6 1 2 3 4