So .... is it tuned or what ?
Type: Posts; User: Cozzm0
So .... is it tuned or what ?
Just for prosperity sake more than anything, and its your chip, you own it, why give it to them. Probably cost you a pretty penny back in the day, and also probably means they don't need to do...
Make sure you ask to keep the old one !
Many different figures for different cars but the 80-85kw range is pretty 'normal' for a standard car. Dynos are great, for comparison figures, but comparing between workshops and between different...
No gasket. The rubber ring is packing material only to stop the sharp edges ripping through the box. Silicone RTV/ Gasket goo is used on the thermostat housing to seal it. You need to clean it real...
A filter cannot suit N14 and N15 sr20. One is imperial thread and the other is metric so be very very careful. Is a blow engine worth saving 10 bucks on a filter. I don’t think so.
Its all liquid gasket between the two halves, there is an o-ring under the end cap cover, but pretty much just reuse the o-ring and goo the crap out of it and you'll be fine.
I wouldn't touch the original paint if i was you, unless its in a bad state. Original paint, on an original car will be worth a lot more, but your car and you're not likely to sell so i guess do...
The only issue i have with these types of bushings over OEM is the maintenance required to keep them lubricated. Once the lubrication 'goes' the bushes bind and because they are much harder than OEM...
Next time it happens try and take a note of what you're doing at the time, what accessories are on, the conditions (hot,cold etc)
I used the factory RNN14 hardline, but many have used a flex hose, required just over 1M depending on how you route it and if you go direct to the slave or use the stock rubber hose on the slave.
Progress?
I have pulled a bushing from and N16 setup I have here and the 300ZX bushes didn’t fit. So I’ll have to get an N15 linkage and compare it but I suspect the N15/16 is going to be the same size.
Found my 300ZX ones.
Main difference I can see is the step before the lip and it doesn’t have the angled edge but I don’t think that really matters for fitment.
If you can take some accurate...
His price is just stupid, but the measurements previous in this thread aren't accurate enough to make a bushing. I have a 3D printer now days so if i get some accurate measurements i'd be able to...
#20 is a bush, #21 is a crush tube not a bushing as such
34557-0M000-BUSH-CONTROL ROD SUPPORT
34556-0M000-TUBE-CONTROL ROD SUPPORT
I have the bushes but no car to try them on.
Guy selling a set of original discontinued ones for $50 on Facebook
EDIt: just spent 45 mins trying to find the bushes to no avail. I had planned...
Yeh just swap the speedo sensor over and that’s all.
It will never be what it once was despite the guy having the data at he won’t ever give it up.
GTI-R slave is useless, you need an N16 slave for this along with the ~10mm spacer plate that goes between the gearbox and the slave cylinder.
I used RNN14 master and pedal personally.
The...
Is there any particular part that you’re having trouble with ?
Jack the car up and look for paint cracking on the black painted metal suspension components.
Never gonna sell it are you ?
Case halves are gasket goo / silicone rtv only. Run a thin bead around the lip on the inner edge of each of the bolt holes to seal it. Don’t use too much and give it 24 hours to cure before you put...
Anything that is cracked really. I only replace when there is visible issues otherwise you'd be refreshing them way too often. Nothing beats OEM quality either, no matter what the aftermarket says...
Its not a linear difference.