Search:

Page 1 of 4 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    4
    Views
    101

    If the CV Shaft nut has come loose for any amount...

    If the CV Shaft nut has come loose for any amount of time it will have eaten the bearing i rekon. Tighten it back up and see how you go but budget for a new bearing at least.
  2. Replies
    7
    Views
    273

    Yeh so just stick to L/100km ... and i'd be using...

    Yeh so just stick to L/100km ... and i'd be using US gallons too. Gallo 16 or 24 ... anybody ... ?

    Either way, still decent economy.
  3. Replies
    9
    Views
    620

    Very few people run autos, so thatís a bit of an...

    Very few people run autos, so thatís a bit of an issue.
  4. Replies
    9
    Views
    620

    I don't know much about autos so i'm really of no...

    I don't know much about autos so i'm really of no help.
  5. Replies
    9
    Views
    620

    have you checked the transmission fluid level ?...

    have you checked the transmission fluid level ? does it feel like it engages the gear at all? is the selector moving the rod at the gearbox end properly? does the speedo rise if you accelerate while...
  6. Thread: Engine Oil

    by Cozzm0
    Replies
    1
    Views
    225

    I use castrol magnatec 10/40 does the job. Just...

    I use castrol magnatec 10/40 does the job. Just make sure the oil you get ISNT GF-5 rated.
  7. Replies
    5
    Views
    905

    I believe that's the drain tube that needs to be...

    I believe that's the drain tube that needs to be 'swapped' to the new antenna ? (totally a guess here, but i recall someone saying it was a real prick to do). I never replaced mine, radio hardly...
  8. Replies
    9
    Views
    1,136

    One spring for left is there, the other one for...

    One spring for left is there, the other one for right (and to stop you shifting into reverse instead of 4th is inside the gearbox, that's how it works.

    usually just the end is broken off the...
  9. Replies
    9
    Views
    1,136

    That kit is for RWD cars. This is the return...

    That kit is for RWD cars.

    This is the return spring under the shifter.

    http://www.micra.com.au/images/technical-articles/gearreturnspring.jpg
  10. Thread: Ecu Options

    by Cozzm0
    Replies
    3
    Views
    439

    PowerFC, Nistune are both good options, Nistune...

    PowerFC, Nistune are both good options, Nistune probably has a bit better support as there are limited people who will have the right software to tune the PowerFC (without using the hand controller)....
  11. Replies
    4
    Views
    879

    As long as the reservoir wasn't empty i wouldn't...

    As long as the reservoir wasn't empty i wouldn't be worried.
  12. Replies
    18
    Views
    2,863

    1. You don't need to soak it. 2. You can pop...

    1. You don't need to soak it.
    2. You can pop the clip off manually by pushing on the chain guide. I would prefer to do this to avoid / reduce the chance of skipping teeth on the cam gears. Some...
  13. Replies
    18
    Views
    2,863

    yeh S15 same part

    yeh S15 same part
  14. Replies
    18
    Views
    2,863

    Timing chain tensioner rattle. Genuine for $30...

    Timing chain tensioner rattle. Genuine for $30 sounds like a steal if its new with the gasket.


    Starter motor is more of a running your fingernails down a chalk board type screeching sound and...
  15. Glad they were able to sort it out for you and...

    Glad they were able to sort it out for you and that you were on the money from the beginning.
  16. I would think the rotor button or the distributor...

    I would think the rotor button or the distributor would have to be seriously damaged to stop the car from starting. I've had them in the car for 80,000km and they were burned up and cracked but the...
  17. Voltages are all OK ?

    Voltages are all OK ?
  18. Thread: Manual for N15

    by Cozzm0
    Replies
    7
    Views
    1,360

    https://www.dropbox.com/s/3dvzowl67xq5isu/Nissan%2...

    https://www.dropbox.com/s/3dvzowl67xq5isu/Nissan%20N15%20Series.zip?dl=0
  19. Replies
    3
    Views
    1,116

    Nope ... Just using a wire link or a paper clip...

    Nope ... Just using a wire link or a paper clip method it will flash the ABS light. See PDF.
  20. ECU Talk Firmware update allows BASE IDLE / TIMING SET !

    Greetings Lads and Lassies !

    I've been working with Peter, the creator of The ECUTalk Consult LCD V2 to add a much needed feature to make his product even better. BASE IDLE / TIMING ADJUST MODE...
  21. Replies
    5
    Views
    883

    I'd start with checking (visually) the globes and...

    I'd start with checking (visually) the globes and see if the filament has dropped onto one of the other wires inside. This happens in tail lights too. the filament breaks, ends up touching the other...
  22. Replies
    8
    Views
    1,520

    ECU won't know or care about the purge solenoid...

    ECU won't know or care about the purge solenoid being gone but you do need it for the vapours from the fuel take to be safely delt with unless you block all that stuff off too (not recommended i...
  23. Replies
    7
    Views
    1,489

    Not for 2.5K for a civic, unless you want a...

    Not for 2.5K for a civic, unless you want a ****ter.
  24. Replies
    7
    Views
    1,489

    Similar cars, not necessarily competition ...

    Similar cars, not necessarily competition

    Toyota Corolla
    Honda Civic
    Holden Astra
    Mitsubishi Lancer
    Proton Satria GTI
    Mazda SP20
    etc etc.
  25. Replies
    2
    Views
    618

    Wanted And prepare to have your wallet lightened...

    And prepare to have your wallet lightened significantly.
Results 1 to 25 of 83
Page 1 of 4 1 2 3 4