Huge thread bump for whoever visits this forum any more, but the issue in the end was the aftermarket dizzy. I purchased a second-hand unit from the wrecker and replaced the inner seal, bearing and...
Type: Posts; User: SLO015
Huge thread bump for whoever visits this forum any more, but the issue in the end was the aftermarket dizzy. I purchased a second-hand unit from the wrecker and replaced the inner seal, bearing and...
Problem solved! So since my last post I did a compression test, which gave results of around 165 psi across all four cylinders. I also tested the fuel pump resistance which was within spec. I noticed...
Frustrating
Yesterday I blocked off the EGR system, which unfortunately has failed to address the hesitation issue. The BPT valve was blocked up with carbon when I took it off so that would have no doubt been...
Hmm fair enough! I'll see how I go in trying to acquire a fuel pressure test kit then.
Speaking from experience, haha? Any idea as to how much fuel would be expected to come out whilst priming the fuel pump, assuming the pump is working as it should?
I'll be sure to check that too. I don't have a fuel pressure gauge but I guess I could always disconnect the fuel feed line at the filter and put it in a jar to see whether there's any issues with...
No worries! Good to know that they're a viable option.
Thanks for the reminder about the fuel pump mate! It is something I need to put a multimeter on and check. I can guarantee it'd be the original one though, and like you said, the strainer is likely...
It's been about 15,000k's max since I replaced the fuel filter. Was either last service or the one before, can't quite remember but it has definitely been done recently
That's something that's definitely on the list to do as well. I have done it before (with the same stuff) but it can't hurt to put another can or two through.
As for the k's, it's just gone over...
It's definitely as per the video, with the 'square edge' of the plug facing to the right.
Yeah that's exactly what was happening. When it was connected it was saying 'could not connect'. I'm not...
Hey mate, I watched that video the other day, that's the procedure I have been attempting to do to no avail. I switch the key to the on position, the check engine light comes on and stays on, I...
I'm wondering whether someone has experienced the same issue I have and can provide some advice on how to sort it out. I have a series 2 N15 sedan (GA16), and I'm trying to retrieve the fault codes...
Sorry to bump this thread again, but I'm once again having the same issue . It is much harder to replicate this time around which is odd, but from 1k rpm up to about 1,500 there is just a huge flat...
Figured I'd make a bit of a post on this process regardless; it may just help someone in the future!
Anyways; the photo below shows the gasket kit that I was supplied (by Repco). This was ordered...
The dizzy was actually quite cheap haha. I think it was $150 or something like that?
I've solved the problem by the way... long post ahead. So I pulled the spark plugs this morning to have a...
I have a feeling it is mate.. there most definitely isn't a 5th lead from the dizzy to the coil. On my dizzy, there are only four leads from the dizzy to the engine and that's it. I'm going to clean...
Yeah mate, it has occurred again today and taking note of the rpm at which it happened it was more around 1,500 rpm. This was once again taking off in first and shifting from first to second or...
Following on from this, I have done a bit of research online with people have similar problems, and a lot of the suggestions said look at the air flow meter. I pulled the plug off of the air flow...
Hey everyone,
I've just noticed an issue where my N15 seems to hesitate for a second or so and then begin to build up speed/revs when taking off and also when shifting ie. from first to second or...
Managed to find some, cheers anyway!
I've replaced both of the hoses from the power steering reservoir. I ripped the old ones off and got replacement lengths from Enzed... was cheap and fairly easy to do. The one that goes to the back...
For Sale/Wanted/Wrecking wanted_parts
Brief Description N15 roof racks
Condition Good
City/Town Adelaide
State SA
Postcode 5000
Contact Details PM
Price 100
Details I'm...
I have a Clutchpro one in mine with a new genuine rear main seal. 6 months on, no dramas so far!