Search:

Type: Posts; User: Cozzm0

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    124

    One spring for left is there, the other one for...

    One spring for left is there, the other one for right (and to stop you shifting into reverse instead of 4th is inside the gearbox, that's how it works.

    usually just the end is broken off the...
  2. Replies
    6
    Views
    124

    That kit is for RWD cars. This is the return...

    That kit is for RWD cars.

    This is the return spring under the shifter.

    http://www.micra.com.au/images/technical-articles/gearreturnspring.jpg
  3. Replies
    6
    Views
    124

    Return spring under the shifter. The 3>5 spring...

    Return spring under the shifter. The 3>5 spring is inside the gearbox.
  4. Thread: Ecu Options

    by Cozzm0
    Replies
    3
    Views
    62

    PowerFC, Nistune are both good options, Nistune...

    PowerFC, Nistune are both good options, Nistune probably has a bit better support as there are limited people who will have the right software to tune the PowerFC (without using the hand controller)....
  5. Replies
    2
    Views
    220

    Wanted Try the facebook groups, unfortunately there are...

    Try the facebook groups, unfortunately there are a lot more people frequenting them than the forum these days.
  6. wow that's an ugly setup.. lol

    wow that's an ugly setup.. lol
  7. The MAF is usually attached to the Airbox with a...

    The MAF is usually attached to the Airbox with a separate Intake Temp Sensor on the GA series motors i believe, but we don't have the GA15 in Australia, only GA16. Sometimes the single wire Oxygen...
  8. Replies
    2
    Views
    264

    Last one i bought brand new $150 with a thicker...

    Last one i bought brand new $150 with a thicker 26mm core. If it was double that price i'd have got a second hand one, but as far as i'm concerned that's cheap enough to make it worth just getting...
  9. Replies
    4
    Views
    332

    As long as the reservoir wasn't empty i wouldn't...

    As long as the reservoir wasn't empty i wouldn't be worried.
  10. Replies
    7
    Views
    835

    Everything connected to the reservoir is LOW...

    Everything connected to the reservoir is LOW pressure and held on by those silly clamps. Sometimes even just undoing the clamp, moving it 5mm down the hose and tightening, will fix it. Just clean it...
  11. Replies
    4
    Views
    332

    It'll be fine. I don't think there's much you can...

    It'll be fine. I don't think there's much you can do wrong with P/S fluid.
  12. Replies
    18
    Views
    1,243

    1. You don't need to soak it. 2. You can pop...

    1. You don't need to soak it.
    2. You can pop the clip off manually by pushing on the chain guide. I would prefer to do this to avoid / reduce the chance of skipping teeth on the cam gears. Some...
  13. Replies
    18
    Views
    1,243

    It could also be the top chain guide between the...

    It could also be the top chain guide between the cam gears i've been told too. but i did tensioner before and it fixed it as long as its genuine tensioner. aftermarket made it worse.
  14. Replies
    18
    Views
    1,243

    yeh S15 same part

    yeh S15 same part
  15. Replies
    18
    Views
    1,243

    Timing chain tensioner rattle. Genuine for $30...

    Timing chain tensioner rattle. Genuine for $30 sounds like a steal if its new with the gasket.


    Starter motor is more of a running your fingernails down a chalk board type screeching sound and...
  16. Replies
    21
    Views
    3,266

    Front brace works good, can use the centre...

    Front brace works good, can use the centre section only if required to clear plenum.
    Rear brace, correct, bolts into the body, but our cars don't have the captive nuts in the frame there so you have...
  17. Replies
    2
    Views
    281

    Oil pan RTV gasket, obviously best time to do it...

    Oil pan RTV gasket, obviously best time to do it is an oil change and i would drain the oil the night before.

    Rocker cover gasket you must must must must spend a heap of time cleaning (with...
  18. Replies
    9
    Views
    500

    How much was the aftermarket unit ?

    How much was the aftermarket unit ?
  19. Replies
    9
    Views
    500

    Yup, that's a shaft seal then.

    Yup, that's a shaft seal then.
  20. Replies
    9
    Views
    500

    Definitely coming from between the head and the...

    Definitely coming from between the head and the dizzy ? if its coming from the body of the distributor at all, then its the internal shaft seal.
  21. Replies
    9
    Views
    500

    There is an internal shaft seal which is a lot...

    There is an internal shaft seal which is a lot harder to replace. Unless you're quite handy i wouldn't recommend attempting it.


    When you installed the new one did you clean the area really well...
  22. Replies
    2
    Views
    241

    There is no oil pan gasket, its gasket goo...

    There is no oil pan gasket, its gasket goo (silicone RTV).

    The worse situation would be that the idle drops for the car to stall each time you push the clutch in, so i think having it stay up a...
  23. Replies
    9
    Views
    602

    That's how all gas struts are charged up in the...

    That's how all gas struts are charged up in the first place. Most of the time they put 'a bit extra' in because the seals will always allow a fraction of gas out. It depends on how bad the original...
  24. Replies
    9
    Views
    602

    mine get used a dozen times a day so i'll quickly...

    mine get used a dozen times a day so i'll quickly see if they fail/soften.
  25. Replies
    9
    Views
    602

    Yeh they are strong, have to really pull the...

    Yeh they are strong, have to really pull the hatch down now, but 1 isn't enough to keep it up, at lest not on my car.

    only fitment issue i had was i had to file a little of the edge of the...
Results 1 to 25 of 489
Page 1 of 20 1 2 3 4