It ended up fixing most of the issue on mine, along with a wheel alignment. The toe was about 2 degrees out, when that was adjusted back in it started looking a bit more normal again. The drivers...
Type: Posts; User: Pnut
It ended up fixing most of the issue on mine, along with a wheel alignment. The toe was about 2 degrees out, when that was adjusted back in it started looking a bit more normal again. The drivers...
I pulled the control arms off on the weekend and went to pickapart and compared them with a couple of cars there, as far as i can see there is near to no change in the control arms. I can see a...
I have looked and there isnt anything obvious like that, nothing looks bent or out of sorts. But i guess that doesnt mean it isnt, so im hoping someone can give me some places to measure to see what...
Joy :/
How likely is it that the subframe itself is damaged, or just the control arms and tie rods?
Are there any documents with measurements i can do to see whats out of place? Like from a...
Does the subframe have bushes that could have torn or moved?
Long story short my son jumped a curb in his Pulsar pretty hard, popped the front tires and dented the rims. We have put on new rims and tires, visually the suspension arms and bushes dont look bent...
Yeah i have done something similar for now, using some sticky sided rubber furniture pads opposite where the rubber boot stops sit which seems to be working for now. Not too sure how they are going...
On our 5 door hatch when the boot lever is pulled the hatch unlocks fine but doesn't spring open as it does on all the other hatch or wagons i have owned, as a result often when the lever is released...
This is the worst one, i didnt bother trying to glue it but it was still working when i pulled it off the wrecked car, so im guessing as long as it stays in place the crack isnt going to have a lot...
So i found a couple of videos and tutorials online about cleaning the tracks and greasing them up so have done this with lithium grease and white lithium spray. Also noticed a small crack where one...
bump?
So i have to replace the electric window mechanism in the drivers door on my sons car, seems to be a typical Nissan wire mechanism failure. I have a secondhand one from the wrecker ready to go in,...
Unfortunately i couldn't see where it is attached on the A pillar, but maybe i wasn't looking hard enough? Im guessing it will require removing the dash to get to though?
Ahh ok that explains a lot actually thanks. I found this gem in one of the workshop manuals, in typical Nissan style it didnt tell me a whole lot as to exactly what the components are, but if that is...
The aerial on my sons N15 Pulsar has snapped off, so i am trying to replace it. If i remove the retaining screws on the roof i can pull the plastic cover up and un-clip the black electrical cable but...
lol, you are telling me! :rolleyes:
I must be a glutton for punishment as i have gotten both my kids an N15 with the same setup, just 1 auto and 1 manual. They are pretty simple and robust cars...
The GA15DE has the MAF inside the throttle body, its a weird setup from my perspective compared with others. Makes it a PITA to get to and clean as you apparently need to remove it from the car, cut...
bump?
My sons N15 Pulsar has a GA15DE engine, from what i have seen they are pretty much the same engine as the GA16DE so i will post this here in the hope of some help. Sorry if it is the wrong spot.
...