Search:

Type: Posts; User: Cozzm0

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    4
    Views
    139

    If the CV Shaft nut has come loose for any amount...

    If the CV Shaft nut has come loose for any amount of time it will have eaten the bearing i rekon. Tighten it back up and see how you go but budget for a new bearing at least.
  2. Replies
    5
    Views
    186

    Smashing the rear 1/4 window on the rear door...

    Smashing the rear 1/4 window on the rear door would be an easy way i can think of. not much you can do other than applying a security film to the window glass but they'll just do more damage if they...
  3. Replies
    5
    Views
    186

    Disconnect the door lock barrel from the locking...

    Disconnect the door lock barrel from the locking mechanism if you never use the key, just depends how they got in. We all know the door frames/windows are the easy way to get in, you can lever the...
  4. Replies
    7
    Views
    306

    Yeh so just stick to L/100km ... and i'd be using...

    Yeh so just stick to L/100km ... and i'd be using US gallons too. Gallo 16 or 24 ... anybody ... ?

    Either way, still decent economy.
  5. Replies
    3
    Views
    254

    Usually they suffer from high idle. Once its...

    Usually they suffer from high idle.

    Once its warmed up does it idle? or still no ?
  6. Yeh prices vary wildly from some sources, it...

    Yeh prices vary wildly from some sources, it depends if you can wait (like most things unless you "REALLY" need them) then i order a large bulk batch from Amayama. Works out sometimes as much as 50%...
  7. GCCorp is basically shutdown. ...

    GCCorp is basically shutdown.


    http://coastmodz.com.au/


    give him a go.


    Also if you can/have the genuine part numbers, you can use websites like amayama.com to order genuine parts dirt...
  8. Replies
    9
    Views
    639

    P Plate drivers want manual so they can do...

    P Plate drivers want manual so they can do burnouts and rip 2nds.
  9. Replies
    9
    Views
    639

    Very few people run autos, so thatís a bit of an...

    Very few people run autos, so thatís a bit of an issue.
  10. Replies
    9
    Views
    639

    I don't know much about autos so i'm really of no...

    I don't know much about autos so i'm really of no help.
  11. Replies
    9
    Views
    639

    have you checked the transmission fluid level ?...

    have you checked the transmission fluid level ? does it feel like it engages the gear at all? is the selector moving the rod at the gearbox end properly? does the speedo rise if you accelerate while...
  12. Replies
    18
    Views
    5,133

    Some plates were special some were Nissan OEM....

    Some plates were special some were Nissan OEM. Iíd say **** outta luck probably because nothing else good runs an R160 size diff. I think some Subaruís did/do but no idea of any kind of lsd plate...
  13. Wanted 5K, no warranty. no 4th gear.

    5K, no warranty. no 4th gear.
  14. Replies
    2
    Views
    459

    2000 N15 is OBD I, not II. Fog light plug behind...

    2000 N15 is OBD I, not II. Fog light plug behind dash dimmer, its bundled up with the dash loom, just need to find the 12V pin in it and go to town, but the fuse tap above is probably the easiest...
  15. Thread: Engine Oil

    by Cozzm0
    Replies
    1
    Views
    228

    I use castrol magnatec 10/40 does the job. Just...

    I use castrol magnatec 10/40 does the job. Just make sure the oil you get ISNT GF-5 rated.
  16. Replies
    10
    Views
    904

    Did you get numbers off the seal ? what...

    Did you get numbers off the seal ? what dizzy/motor model ?
  17. Replies
    11
    Views
    668

    1 is front edge, there is a spring clip about...

    1 is front edge, there is a spring clip about 10mm above the two other buttons. if you push the whole unit back and forth (towards front of car then towards back of car) you should fee the...
  18. Replies
    11
    Views
    668

    gently slide a paddle pop stick down from the...

    gently slide a paddle pop stick down from the front edge and it will lift out from the front edge.

    sometimes you can just pull it up from the front, but other times they're kinda stuck in there....
  19. Replies
    11
    Views
    668

    They're one piece you need one from a 5 door car.

    They're one piece you need one from a 5 door car.
  20. Replies
    3
    Views
    541

    Does it grind going into reverse ?

    Does it grind going into reverse ?
  21. Replies
    10
    Views
    904

    Yeh that part number is correct.

    Yeh that part number is correct.
  22. Replies
    10
    Views
    904

    Yup.

    Yup.
  23. Replies
    7
    Views
    559

    Take to an exhaust shop and see if they have a...

    Take to an exhaust shop and see if they have a gasket that fits. Aftermarket headers will always just have a flat flange designed for a flat gasket, similar to the subaru one you linked but usually...
  24. Replies
    7
    Views
    559

    The stock rings won't work for an aftermarket...

    The stock rings won't work for an aftermarket exhaust though, because they don't use part of the pipe protruding through the flange to locate them.
  25. Replies
    7
    Views
    559

    pic

    pic
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4