Hey All,
Making a pod filter setup for my pulsar, when I took the intake off last it seemed a spaghetti of hoses, what do I actually need to keep?
Thanks in advance!
Printable View
Hey All,
Making a pod filter setup for my pulsar, when I took the intake off last it seemed a spaghetti of hoses, what do I actually need to keep?
Thanks in advance!
how far up the intake did you take off? just the airbox or all the way to the plenum?
pics?
All the way up plenum; airbox, intake piping, reso box.
iacv hose.without it you will stall.
hose to fuel canister maybe.rta
rocker cover hose for crankcase ventilation.rta
Planning to use a silicone reducer and some steel pipe, drilling and tapping 3 fittings in for the lines as a bit of a project on the holidays.
Take a look at two pics of the Red Jett.
Cold Air Intake at bottom left (passengers side) of front spoiler. Used end of a funnel to increase opening to 120 mm, for ram effect.
80 mm flex pipe to feed into Cold Air Box, encapsulated in a heat protector, then 3-A Racing pod via a BOMZ metal air intake into the throttle body.
Cheers…
Attachment 1580Attachment 1581
Bonus, takes me back to 1985. . .
Pics of my Alfa Romeo GTV 2.0 engine, with its tuned extractors and two double barrel Webber carbies. One carby for each cylinder.
Temperamental old gal she was . . .
Attachment 1583Attachment 1582
That little filter off the rocker cover, that is just for ventilation?
Attachment 1584
Is that little adapter off the AFM something easy to find? swear I have seen em at SCA before.
I can see the cheap fuel filter at the back for the rocker cover in the middle, I meant the thing on the RHS. The fuel filter is nifty though!
I'm not messing with the AFM, I mean like an adapter for a pod that bolts up to the AFM housing, are these easy to find?
The RHS K&N filter is probably not legit, but lets ERG gases out a little (vent to air). I clean that filter every 20,000.
Note I have removed all the ERG stuff on the intake manifold.
Here tizz: Your adapter.
http://coastmodz.com.au/product_info.php?products_id=43
Cheers
My pod:
http://coastmodz.com.au/product_info.php?products_id=4
Bump, I measured the the stock intake pipe at about 8.5cm, which is about 3.3", what size silicon joiners did you use off the TB, did 3" fit or are you using 3.5"?
This is what ya need:
http://www.nissanforums.com/ga16de-1...ke-thread.html