PDA

View Full Version : N14 Radiators



Ruddigger
26-10-2015, 05:41 PM
Can any remember what the size differences is between a

Aus Spec Rad

Jap Spec Rad

Pic of a japspec here
https://fbcdn-sphotos-b-a.akamaihd.net/hphotos-ak-xap1/v/t1.0-9/12189586_10153838529061019_3986908317186258225_n.j pg?oh=5be7698a84843af50fb74822b05ec2e3&oe=56889325&__gda__=1451554416_cf017fa5e25655888788b19ba27cd60 0

Cozzm0
26-10-2015, 06:50 PM
16mm i thought was the thicker one and thinner was 10mm, but 10mm just seems too thin so not sure if my memory is correct there...

You can get factory type (i.e not stupid fully alloy) with a 26mm core if you need. If you are (or can do) an oil cooler it will probably do more good than just whacking a bigger radiator in there.

Ruddigger
26-10-2015, 08:14 PM
Yer 10mm is to small i think , im thinking Jap 16mm and Aus 20mm.

Ill do some recon next time im at the wreckers.

Leesss
26-10-2015, 08:50 PM
I thought it was 10, but I have a 26mm in my challenge car

Ruddigger
27-10-2015, 09:28 AM
I thought it was 10, but I have a 26mm in my challenge car

is that ok via the rules?

Martin
27-10-2015, 09:57 AM
The rules only detail the stock width & height - no issue with thickness

I'm just running a new heavy duty unit which is 16mm ($85 from eBay- plastic top and bottom)
Out on the track she runs at 85 degree rock solid - even during the 45 minute enduro
I'm planning on putting some mesh over the bumper air intake cos the radiator fins are copping a hiding (stones and rubber)

Ruddigger
27-10-2015, 10:21 AM
Sweet ill pull the PWR out of JAPSSS :P

gt4rce
08-11-2015, 08:45 AM
10mm if i recall correct was the jap core thickness.